FastCap Forum

FastCap Discussions => Ask FastCap => Topic started by: sjdorst on July 15, 2017, 10:54:59 AM

Title: FastEdge around a tight radius INSIDE corner - Any tips?
Post by: sjdorst on July 15, 2017, 10:54:59 AM
I'm planning to use FastEdge (Wood FastEdge. Finished Maple) around the edges of the prefinished Maple plywood I'm using for a project. And I have 2 places where I need to apply it through an inside radius corner - and the radii (30 and 42 mm) are far smaller than the radii shown in the demonstration video (https://youtu.be/Cs_z74yHqPA (https://youtu.be/Cs_z74yHqPA)).

Any tips for installation through such tight radii??
Title: Re: FastEdge around a tight radius INSIDE corner - Any tips?
Post by: FastCap on July 18, 2017, 04:58:49 PM
The most important thing is to heat the material so it completely relaxes and will lay in a tight inside radius.