FastCap Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - guardo83

Pages: [1]
1
FastCap Product Problems / FastEdge tear out
« on: February 16, 2018, 08:00:02 AM »
I'm doing a project with unfinished Maple FastEdge.  So far 2 out 8 edges have come out. Otherwise, when trimming the edges there is a lot of tear out into the face. So much that sanding would not fix it. 1/4 to 1/2 the face. The 2 that came out required sanding. I'm using the quad pro trimmer that I purchased new for this project. I've watched the video, that's pretty much what I'm doing. I thought it was about how I was rolling at first. But I've been tolling like crazy and even doing the pre trimming with a utility knife. Still bad tear out.

Any thoughts on how I can make this work? I'm not even half done.

3/4 top choice plywood sanded and dust removed, 15/16 unfinished Maple FastEdge.


Pages: [1]